Jaw Crusher (PE and PEX Series)
The jaw crusher uses a movable jaw that applies compressive force, splitting and bending to break rock against the fixed jaw. It is an intermittent crushing process driven by an eccentric shaft.
Range and configuration
In a typical circuit, PE series models serve as primary crushers handling run-of-mine rock. PEX series units operate as secondary crushers, reducing primary product to a size suitable for milling or further processing.
The performance ranges shown in the table are aggregated from the full catalogue model list. They do not represent parameters achievable by any single unit at the same time. Actual capacity depends on the specific model selected and the duty conditions. Buyers should select a model by matching feed size, required capacity, and operating conditions to the individual specification sheet, not by treating the range as a guarantee.
| Series | Model range | Max feed size | Capacity |
|---|---|---|---|
| PE Standard | PE100x150 to PE1500x2100 | 80-1200 mm | 0.5-600 t/h |
| PEX Fine Crushing | PEX150x750 to PEX300x1300 | 120-250 mm | 8-80 t/h |
The ranges above summarise the catalogue model table. They are not parameters that any single machine reaches simultaneously. Capacity must be matched to a specific model and duty.
Selection fields to confirm
Before a specific model can be fixed, define the maximum feed lump size, required product size range, and target throughput. Confirm the ore’s compressive strength, abrasiveness, and moisture content, as these influence liner life and capacity. Provide the available motor voltage and space constraints for the installation. This ensures the selected crusher matches the duty without over- or under-sizing.
- Feed opening, maximum feed size and discharge setting range
- Rated capacity, eccentric shaft speed and motor power
- Machine dimensions, weight and foundation loading
- Jaw plate wear life
- Ore compressive strength, abrasiveness, clay and moisture content
ISO 9001 / ISO 14001 / ISO 45001 / ISO 9712 / CE / CSA W47.1 / CNAS accredited laboratory
Send the duty, get a sized proposal
Tell us the ore, the throughput and the target product. Our process engineers come back with a flowsheet position, a model shortlist and the testwork we would need to confirm it.